IPCop will automatically choose a Network mask. You may modify the network mask as needed. Your Red network must have a static address if you wish to use IPCop's aliasing feature. Network Card assignment will follow hardware detection, where you assign NICs to Red, Green, Blue and Orange networks, depending on the number of interfaces found. Then you assign numeric addresses to your networks, and enter DNS and Gateway settings.
Use this option if your Red network interface card has to obtain a leased address from a router or cable modem, using DHCP. Red interface selection Prev 4.
Found that by closing the explorer window i was using to look in the directory containing the file solved the problem and this works now. Maybe hardware compatibility issue. Good luck. It looks like it is writing the image correctly. Perhaps the following will help others.
I was unable to make a usable boot disc using the dd. I looked up problems with this and eventually came across a solution that worked for me. Why is so complicated to make bootable an usb key with ipCop???? Others distro are so simple!! Not run on my computer. IPcop is a very old product at this point. Thank you so much! Your email address will not be published.
Computers , Tricks, Tips, or Hacks. Attention: This content is 13 years old. Please keep its age in mind while reading as its contents may now be outdated or inaccurate. Sabu May 19, at pm Thanks a loooooooooooooooooooooooot -: I was looking for it for the same problem. Roberto M June 3, at pm thanks, it was easy to follo, wbut a little problem trying to find the usb-fdd image file but finally it was rewarding again thanks a lot.
Ben Wilson July 13, at pm Dude, many thanks indeed. I would recommend this to a friend, or someone who wants to build a firewall system. The Network Configuration Menu will take you through the steps necessary to configure them. This dialog lets you choose your network configuration type.
When you select Ok , you will be returned to the Network Configuration Menu , above. Tab to the Drivers and card assignments line, select it and press the Enter key. If your RED interface uses an Ethernet connection, configure it, too. If your RED interface does not use an Ethernet connection, skip to the discussion about configuring additional network interfaces.
After configuring your Ethernet card and driver information for the other interfaces, return to the Network Configuration Menu by selecting the Done button. This is dependent on your ISP and connection. Enter it in the IP address box of the dialog. IPCop will automatically choose a Network mask.
You may modify the network mask as needed. This probably is not IPCop's hostname. If it's needed, you can probably use the first part of the fully qualified domain name you noted while gathering the network parameters , above.
If your connection is via PPPOE, your ISP will supply all necessary information during the initial connection, so you won't have to do anything, after selecting it. This address is almost always All three network addresses must be on different networks, i.
When you are done, select the Ok button, to return to the Network Configuration Menu. You will only need to use this dialog if you are using a static IP address configuration for your RED interface.
If you subsequently change your RED network to use another method for obtaining its address, the servers in this dialog will override those supplied by your ISP.
On one hand, this is a good way to override parameters. On the other hand, this can cause endless confusion. When switching from static IP addressing remember to clear these values. Otherwise, do not enable the server, and continue with setting passwords , below.
Dynamic Host Configuration Protocol allows computers to configure their network interfaces when they are booted. Do not use your full network range for DHCP. At a minimum leave out IPCop's address. As a practical matter, at some future point in time you may wish to run servers that are only accessible from within your GREEN network.
0コメント